Digital I/O modules present a 40-pin male 0.1in (series 2) or 0.05in (series 3) dual-row header to the external world. All analog signals present a male SMB connector, including the external sync signal, A2D clock/data, D2A clock/data, and the CXD modules' 75ohm SMB connectors.
Cables for ICE Products
The following cables used to interface with ICE products are available for purchase (see the Pricing page):
|Part No.||Description||Available for Purchase|
|ICE-CAB-SB5||Coaxial 5-foot female SMB to male BNC for A2D, D2A, and CXD modules||Yes|
|ICE-CAB-MM5||Coaxial 5-foot male MMCX to male BNC for our Slim-PIC cards||No|
|ICE-CAB-SMA5||Coaxial 5-foot male SMA to male BNC for our LB2D and D2AWG modules||Yes|
|ICE-CAB-HD5||40-pin high-density ribbon cable for E2D, D2E, T2D, and D2T modules (pinout information below)||No|
|ICE-CAB-STST6||Fiber ST 6" jumper cable||Yes|
Pinout Diagrams and Information
P/N0 -15 are positive/negative data bits, and P/NCLK are the clock.
The first two pairs of NCs may be used for parity. The last NC pair is necessary for clock integrity.
Please note: The standard setup is LSB=0, MSB=15.
16-bit Differential I/O Ribbon Cable
where P/N0-15 are positive/negative data bits, P/N16-17 are parity on some modules, and P/NCLK are the clock.
A 40-pin ribbon to ELCO transition panel for a MIDAS DSM is available through STL at 937-429-7470.
- The 6-position panel with Low-Density Connectors for series 2 cards is part 1013-0118-06.
- The 6-position panel with High-Density Connectors for series 3 cards is part 1013-0130-06.
- The 8-position panel with High-Density Connectors for series 3 cards is part 1013-0131-06.
The connector on the standard 36-pin ribbon to ELCO MIDAS DSM transition panel is shown below.
These connectors are available through Newark at 1-800-463-9275, part # 93F8099.
See HELP CARDS MIDASDSM for more information.
MIDAS Digital Switch Matrix Panel Connector (36-pin)
where P/N0-15 are positive/negative data bits, and P/NCLK are the clock.
These cables are available for purchase. For pricing, please see the Pricing page.